Ftdi Ft232r Usb Uart Ttl Poort Cable - Iskra Kamstrup Landis Dutch Smart Meter Dsmr P1 E350
SKU #4939893375012
Тип: System & Power Cables
Доступность: В наличии
Цены начиная с: R$ 208.27
БЕСПЛАТНАЯ ДОСТАВКА ПО ВСЕМУ МИРУ
Specifications:
Cable length:180CM
Signal:
TTL 5V level
Chip:
FTDI FT232R
This cable is specially for the Dutch Kaifa Smart Meter
Communication with Domoticz on Raspberry.
FTDI FT232R USB TTL5V to RJ11 6P6C Cable
for ISKRA AM550 kaifa ma105 Iskra ME 382 Kamstrup 162 382 en351 Landis + Gyr E350 P1 Poort Slimme Meter
The P1 port, which is the RJ-11 connection, has the serial protocol where standard IEC-62056-21 is used.
Schematische voorstelling P1 poort (ESMRv5.0 P1)
Note:
Does not include the Dutch Smart Meter
The P1 port is a 6p6c socket, commonly referred to as RJ12. The RJ11/RJ12 plug is the one we have known for years as the telephone plug. You can go with an RJ11 plug that has only the 4 middle pins connected, but your best option is to use an RJ12 connection with all 6 wires connected. That way you can optionally use the power output from the P1 port to power the reading device. The 6 pins of the P1 port are wired as shown in the table below.
Specifications:
1 +5V Power supply line (250mA)
2 Request Data request (high)
3 Data GND Ground for the data signal
4 N.C. Not Connected
5 Data Serial data output signal
6 Power GND Power ground
Pin 4 is not used.
Pin 1 and 6 provide power that can be used by a connected device. According to the DSMR 5.0 standard, this output is capable of providing 250mA at 5V. This power output was not available pre-DSMR 4. But the 4.x.x standard does not give details of its maximum load, only the DSMR 5.0 standards description.
Pin 5 and 3 are the serial output pins and provides a logical 1 with an output voltage of less than 1V, and a logical 0 with an output voltage of more than 4V. This is commonly referred to as TTL Serial. The Landis meter has an open collector output (pin 5), meaning that we need to add a pull-up resistor of 1-2k to allow the data output to switch between these states. Note that the output is inverted, so we'll have to invert the signal by software or hardware. The baudrate is 115200 bps with 8 bits, no parity and 1 stop bit (8N1). Up to DSMR 3.x the rate was only 9600 baud.
Pin 2 can be used to control the dataflow from the meter. Make this pin high (>4V) to have the meter send it's data on the data output pin. You can either make this permanently high, resulting in a constant flow of meter data every 10 seconds, or only when you want to request data. To stop receiving data, an OSM needs to drop the “Data Request” line - that is, set it to “high impedance”. Data transfer will stop immediately in such case. For backward compatibility reason, no OSM is allowed to set “Data Request” line low (set it to GND or 0V).
Товар не соответствует описанию? Свяжитесь с нами в течение 30 дней после его получения!
В случае отмены деньги будут возвращены на ваш счет в течение 3 дней.
Cable length:180CM
Signal:
TTL 5V level
Chip:
FTDI FT232R
This cable is specially for the Dutch Kaifa Smart Meter
Communication with Domoticz on Raspberry.
FTDI FT232R USB TTL5V to RJ11 6P6C Cable
for ISKRA AM550 kaifa ma105 Iskra ME 382 Kamstrup 162 382 en351 Landis + Gyr E350 P1 Poort Slimme Meter
The P1 port, which is the RJ-11 connection, has the serial protocol where standard IEC-62056-21 is used.
Schematische voorstelling P1 poort (ESMRv5.0 P1)
Note:
Does not include the Dutch Smart Meter
The P1 port is a 6p6c socket, commonly referred to as RJ12. The RJ11/RJ12 plug is the one we have known for years as the telephone plug. You can go with an RJ11 plug that has only the 4 middle pins connected, but your best option is to use an RJ12 connection with all 6 wires connected. That way you can optionally use the power output from the P1 port to power the reading device. The 6 pins of the P1 port are wired as shown in the table below.
Specifications:
1 +5V Power supply line (250mA)
2 Request Data request (high)
3 Data GND Ground for the data signal
4 N.C. Not Connected
5 Data Serial data output signal
6 Power GND Power ground
Pin 4 is not used.
Pin 1 and 6 provide power that can be used by a connected device. According to the DSMR 5.0 standard, this output is capable of providing 250mA at 5V. This power output was not available pre-DSMR 4. But the 4.x.x standard does not give details of its maximum load, only the DSMR 5.0 standards description.
Pin 5 and 3 are the serial output pins and provides a logical 1 with an output voltage of less than 1V, and a logical 0 with an output voltage of more than 4V. This is commonly referred to as TTL Serial. The Landis meter has an open collector output (pin 5), meaning that we need to add a pull-up resistor of 1-2k to allow the data output to switch between these states. Note that the output is inverted, so we'll have to invert the signal by software or hardware. The baudrate is 115200 bps with 8 bits, no parity and 1 stop bit (8N1). Up to DSMR 3.x the rate was only 9600 baud.
Pin 2 can be used to control the dataflow from the meter. Make this pin high (>4V) to have the meter send it's data on the data output pin. You can either make this permanently high, resulting in a constant flow of meter data every 10 seconds, or only when you want to request data. To stop receiving data, an OSM needs to drop the “Data Request” line - that is, set it to “high impedance”. Data transfer will stop immediately in such case. For backward compatibility reason, no OSM is allowed to set “Data Request” line low (set it to GND or 0V).
ГАРАНТИЯ
Мы вернем вам деньги, если товар не будет доставлен в течение 40 дней после покупки. У вас есть 2 недели, чтобы запросить возврат - до 60-го дня.Товар не соответствует описанию? Свяжитесь с нами в течение 30 дней после его получения!
В случае отмены деньги будут возвращены на ваш счет в течение 3 дней.
Отзывы
Very Fast Delivery. 11 Aug 2020 11:21
Shopper from NETHERLANDS
ПОХОЖИЕ ПРОДУКТЫ
Rf Coaxial Cable - Rg400 30ft/10m
FREE SHIPPING
Dc 12v Power Cable 5.5mm*2.1mm , Male -female Connector
FREE SHIPPING
Computer Power Cables, Wiring Organizer Comb Patterrn Clips
FREE SHIPPING
2 Pin Eu Power Supply Cable Cord For Desktop/laptop
FREE SHIPPING
Fm Am Radio Car Antenna - Extension Cable Cord
FREE SHIPPING
Solar Power Photovoltaic Cable Pv1-f
FREE SHIPPING
Octoplus Dongle, Frp Usb, Uart 2-in-1 Boot Cable
FREE SHIPPING
Atx Power Cable For Hp Z220 Z230 Sff Mainboard Server Workstation
FREE SHIPPING
Universal Usb To Dc 5.5x2.1mm Plug Power Cord With 10 Connectors
FREE SHIPPING
8p8c Rj45 Modular Plug
FREE SHIPPING
Ac Power Extension Cord- Power Cable For Pc Computer
FREE SHIPPING
Usb Turn To Dc Power Male Plug Jack Adapter, Converter Cable Cord
FREE SHIPPING
Male To Female Right Angle 4 Conductor Power Extension Cable
FREE SHIPPING
Dcsd Alex Serial, Port Cable Engineering
FREE SHIPPING
15 Pin Mini Usb Pcb Connector Male Jack For Digital Camera
FREE SHIPPING
Lmr200- N Male Plug To M Male Extension, Cord Rf Coaxial Cable For Antenna
FREE SHIPPING
Cee7/16 To Iec320 C7 Angle Converter, Extension Cable For Samsung, Philips, Sony, Led Tv
FREE SHIPPING
Battery Snap-t Type, Clip Lead Wire Connector, Power Supply Cable
FREE SHIPPING
10a 240v Ac-universal Power Supply Adapter Plug
FREE SHIPPING
Pogo Pin, Usb Cable For Guard Patrol, Tour Reader
FREE SHIPPING